Ricoh D127 - Adjusting Main-Scan Magnification; Scanning

• The diagram shows the paper on the copy tray. Note that the paper is output with the face
down.
3.
Adjust the blank margin (SP2-103).
SP Specification
SP2-103-001 (Leading Edge) [A] 3 +1/-3 mm
SP2-103-002 (Trailing Edge) [B] 3 +1/-3 mm
SP2-103-003 (Left Side) [C] 2 ± 2 mm
SP2-103-004 (Right Side) [D] 2 ± 2 mm
• The "Left Side" and "Right Side" comes to your left-hand side and right-hand side respectively
when you view the copied image with the leading edge upwards.
4.
Select "Cancel" in SP2-109-001 after finishing the adjustment procedure.
Adjusting Main-Scan Magnification
Use the Grid Pattern (Grid Vertical Line) (SP2-109-001 > 5) for this adjustment.
SP Specification
SP2-102-001 (Main scan Mag.) 0 ± 0.5%
1. Print out the test pattern.
2.
Measure the sides of squares. Each side should be 2.7-mm long.)
3. Adjust the main-scan magnification (SP2-102-001: Main Scan Mag.).
4. Select "Cancel" in SP2-109-001 after finishing the adjustment procedure.
Scanning
Preparation:
•
Before adjusting scanning, adjust printing (
p.134 "Printing").
•
To adjust scanning, use the A4 test chart.
4. Replacement and Adjustment
136