1. Scanner Cover and Exposure Glass ( p.83 " Scanner Cover and Exposure Glass")
2.
Remove the long bracket [A] and the guide rod bracket [B]. (
x 4)
3.
Lift the guide rod [C] as the red arrow shows.
4. Put the belt [D] off as blue arrow shows to release the LED Unit [E] from the guide rod.
• Do not loosen the paint-locked screws holding the lens in place.
•
After installing a new lens, carry out copy adjustments (
p.134 "Adjusting Copy Image
Area").
Scanner Motor
4. Replacement and Adjustment
84
To Next Page
Loading...
