001 Engine Execution type SP (DFU)
5995 Factory Mode
001 - [0 to 1 / 0 / 1 STEP/step] (DFU)
SP6-XXX (Peripherals)
6006*
ADF Adjustment ( "DF Image Adjustment" in the "Adjusting Copy Image Area")
NOTE: Available menus depend on the machine model and its configuration.
001
Side-to-Side Regist Adjustment
Face
[–2.0 to +2.0 / 0.0 / 0.1 mm/step]
002 Side-to-Side [–2.0 to +2.0 / 0.0 / 0.1 mm/step]
003 Leading Edge Duplex Front [–5.0 to +5.0 / 0.0 / 0.1 mm/step]
004 Leading Edge Duplex Rear [–5.0 to +5.0 / 0.0 / 0.1 mm/step]
007 Rear Edge Erase [–5.0 to +5.0 / 0.0 / 0.1 mm/step]
6007 ADF INPUT Check
009
Original Detection [0 to 1 / 0 / 1 STEP/step]
Displays ADF original sensor information. When the sensor detects an original, this SP’s
value becomes “1”.
013
Registration Sensor [0 to 1 / 0 / 1 STEP/step]
Displays ADF registration sensor information. When the sensor detects an original, this
SP’s value becomes “1”.
015 Feed Cover Sensor [0 to 1 / 0 / 1 STEP/step]
Displays ADF sensor information. When the cover opens, this SP’s value becomes “1”.
6008 ADF OUTPUT Check
003
Feed Motor Forward [ON/OFF]
Makes the paper transfer motor rotate to check ADF condition against operational load.
System Service Mode
103
To Next Page
Loading...
