1. Make a temporary test chart as shown in the above diagram. Use the "A4/8.5 x 11" paper to
make it.
2.
Place the temporary test chart on the ARDF.
3. Make a copy.
4. Measure the distance between the side edge of the image area and the side edge of the paper
[A].
(The diagram shows the paper on the copy tray. Note that the paper is output with the face down.)
5.
Adjust the side-to-side registration (S to S/Front Regist: SP6-006-001, S to S/Rear Regist:
SP6-006-002). The image area moves to the rear side of the copier when you specify a larger
value.
6. Measure the distance between the leading of the image area and the leading edge of the paper
[B].
7. Adjust the leading edge registration (Leading Regist: SP6-006-003). The image area moves to the
right side of the copier when you specify a larger value.
8. Measure the distance between the trailing edge of the image area and the trailing edge of the
paper [C].
9. Adjust the erased area on the trailing edge (Trailing Erase: SP6-006-007).
10. Compare the copy with the original.
Adjusting Copy Image Area
139
To Next Page
Loading...
