Ricoh D127 - Page 187

875 B
Mass erasing error (HDD erasing)
An error was detected before HDD
erasing when HDD/Data erasing
was executed.
(The case data erasing failed, or The
case HDD logic erasing failed)
• Failed HDD logic erasing
•
Failed to erase the data each
module has
1. Reboot the machine
876
Log Data Error
An error was detected in the handling of the log data at power on or during machine
operation. This can be caused by switching the machine off while it is operating.
-001 C Log Data Error 1
• Damaged log data file in the HDD
1.
Initialize the HDD with SP5832-004.
-002 C Log Data Error 2
• An encryption module not installed
1.
Disable the log encryption setting
with SP9730-004 (“0” is off.)
2. Install the DESS module.
-003 C Log Data Error 3
• Invalid log encryption key due to
defective NVRAM data
1. Initialize the HDD with SP5832-004.
2. Disable the log encryption setting
with SP9730-004 (“0” is off.)
-004 C Log Data Error 4
• Unusual log encryption function due
to defective NVRAM data
1.
Initialize the HDD with SP5832-004.
-005 C Log Data Error 5
• Installed NVRAM or HDD which is
used in another machine
1. Reinstall the previous NVRAM or
HDD.
2. Initialize the HDD with SP5832-004.
-099 C Log Data Error 99
• Other than the above causes
1.
Ask your supervisor.
SC Tables
185