Ricoh D127 - Page 236

2001 2
ID sensor pattern [0 to 400 / 200 / 10 V/step]
Adjusts the voltage applied to the charge roller for the ID sensor pattern (as part of
charge-roller voltage correction). Setting the same value as “SP2-201-002” is
preferable.
2001 3
Temporally Input [-2500 to 0 / 0 / 10 V/step]
Inputs the voltage value. Too small value may cause the charge roller tainted. Too large
value may cause attaching carrier particles in developer, on a printed paper. The value
from – 1800 V to 1600 V is preferable.
2005* Charge Bias Correction
2005 1 Vsdp Min [0 to 100 / 90 / 1 %/step]
2005 2 Vsdp Max [0 to 100 / 95 / 1 %/step]
2005 3
Charge Roller Bias Correction (Step) [0 to 200 / 50 / 1 V/step]
Sets correction value by one step for bias adjustment to meet SP2001-001 setting value.
2102* Main Scan Adj.
2102 1 Magnification Adj. [-0.5 to 0.5 / 0 / 0.1%/step]
2102 13 Beam Pitch Dot [0 to 20 / 5 / 1 dot/step]
2005 14 Beam Pitch Subdot [0 to 15 / 3 / 1 sub-dot/step]
2103* Erase Margin Adj.
2103 1 Leading Edge
[0 to 4 / 3 / 0.1 mm/step]
2103 2 Trailing Edge
2103 3 Left
[0 to 4 / 2 / 0.1 mm/step]
2103 4 Right
2104* Unit LD Power Adj.
2104 1 LD1
[60 to 140 / 100 / 0.1 %/step]
2104 2 LD2
3. Appendix: SP Mode Tables
28