Ricoh D127 - Page 360

005 Bit Switch 5 0 1
bit 0 DFU - -
bit 1 Multiple copies if a paper size or type mismatch
occurs
Disabled
(single
copy)
Enabled
(multiple)
If a paper size or type mismatch occurs during the printing of multiple copies, only a
single
copy is output by default. Using this BitSw, the device can be configured to
print all copies even if a paper mismatch occurs.
bit 2 DFU - -
bit 3 [PS] PS Criteria Pattern3 Pattern1
Change the number of PS criterion used by the PS interpreter to determine whether a
job is PS data or not.
Pattern3: includes most PS commands.
Pattern1: A small number of PS tags and headers
bit 4
Increase max number of the stored jobs to 1000
jobs.
Disable
(100)
Enable
(1000)
Enabled: Changes the maximum number of jobs that can be stored on the HDD via
Job Type settings to 1000. The default is 100.
bit 5 DFU - -
bit 6 Method for determining the image rotation for the
edge to bring on
Disable Enable
Enabled: The image rotation will be performed as they were in the specifications of
older models for the binding of pages of mixed orientation jobs. The old models are
below:
-PCL-: Pre-04A models
bit 7 Letterhead mode printing
Disable
Enable
(Duplex)
Routes all pages through the duplex unit. If this is disabled, simplex pages or the last
page of an odd-paged duplex job, are not routed through the duplex unit. This could
result in problems with letterhead / pre-printed pages.
3. Appendix: SP Mode Tables
152
RTB 31
Bit 4: Should be 750 jobs