Ricoh D127 - Page 385

Code Meaning Suggested Cause/Action
22-00
Original length exceeded the
maximum scan length
• Divide the original into more than one page.
•
Check the resolution used for scanning. Lower the
scan resolution if possible.
• Add optional page memory.
22-01
Memory overflow while
receiving
• Wait for the files in the queue to be sent.
•
Delete unnecessary files from memory.
• Transfer the substitute reception files to an another
fax machine, if the machine’s printer is busy or out of
order.
• Add an optional SAF memory card or hard disk.
22-02
Tx or rx job stalled due to line
disconnection at the other end
• The job started normally but did not finish normally;
data may or may not have been received fully.
• Restart the machine.
22-04
The machine cannot store
received data in the SAF
• Update the ROM
•
Replace the FCU.
22-05
No G3 parameter
confirmation answer
• Defective FCU board or firmware.
23-00
Data read timeout during
construction
• Restart the machine.
•
Replace the FCU.
25-00
The machine software resets
itself after a fatal transmission
error occurred
• Update the ROM
•
Replace the FCU.
F0-xx V.34 modem error • Replace the FCU.
F6-xx SG3 modem error
• Update the SG3 modem ROM.
•
Replace the SG3 board.
• Check for line noise or other line problems.
• Try communicating another V.8/V.34 fax.
Fax Error Codes
177