Ricoh D127 - Page 42

2. Pull the paper tray part way out of the unit, remove the tape and cardboard [A], and push the tray
back in.
3. Set the copier onto the paper tray unit.
• When installing a second paper tray unit, place on the first paper tray unit before placing the
copier onto the pair of paper tray units.
4. Remove the paper tray(s) from the paper tray unit(s).
5. Load paper into the paper tray(s). Adjust the side and end fences as necessary. If loading 81/2"x
14" paper, remove the end fence and set it into the special compartment.
6. Set the paper tray(s) back into the paper tray unit(s).
2. Installation
40