0
Paper size selection priority
0: Width
1: Length
0: A paper size that has the same width as the
received data is selected first.
1: A paper size which has enough length to print
all the received lines without reduction is selected
first.
1
Paper size selected for printing A4
width fax data
0: 8.5" x 11" size
1: A4 size
This switch determines which paper size is selected
for printing A4 width fax data, when the machine
has both A4 and 8.5" x 11" size paper.
2
Page separation
0: Enabled
1: Disabled
1: If all paper sizes in the machine require page
separation to print a received fax message, the
machine does not print the message (Substitute
Reception is used).
After a larger size of paper is set in a cassette, the
machine automatically prints the fax message.
3-4
Printing the sample image on reports
Bit 4: 0, Bit 3: 0 = The upper half only
Bit 4: 0, Bit 3: 1 = 50% reduction in sub-
scan only
Bit 4: 1, Bit 3: 0 = Same size
Bit 4: 1, Bit 3: 1 = Not used
“Same size” means the sample image is printed at
100%, even if page separation occurs.
User Parameter Switch 19 (13H) bit 4 must be set
to “0” to enable this switch.
Refer to Detailed Section Descriptions for more on
this feature.
5-6 Not used Do not change the settings.
7
Equalizing the reduction ratio among
separated pages
(Page Separation)
0: Enabled
1: Disabled
0: When page separation has taken place, all the
pages are reduced with the same reduction ratio.
1: Only the last page is reduced to fit the selected
paper size when page separation has taken
place. Other pages are printed without reduction.
Printer Switch 0F [SP No. 1-103-016]
No FUNCTION COMMENTS
5. Appendix: Fax Service Program
216
To Next Page
Loading...
