2
Monitor speaker during memory
transmission
0: Disabled 1: Enabled
1: The monitor speaker is enabled during memory
transmission.
3-5 Not used Do not change the settings.
6
Private G3 FAX line enabled/
disabled switch
0: Disabled / 1:Enabled
This function is used in the situation that one fax is
connected to the other directly without switching
equipment.
7 Not used Do not change the settings.
G3 Switch 01 [SP No. 1-105-002]
No FUNCTION COMMENTS
0-3 Not used Do not change the settings.
4
DIS frame length limitation
0: OFF 1: 4 bytes
1: The bytes in the DIS frame after the 4th byte will not be
transmitted (set to 1 if there are communication problems
with PC-based faxes which cannot receive the extended
DIS frames).
5 Not used Do not change the setting.
6
Forbid CED/AMsam output
0: Off
1: On (Forbid output)
Do not change this setting (Default: 0: Off), unless
communication problem is caused by a CED or ANSam
transmission.
7 Not used Do not change the setting.
G3 Switch 02 [SP No. 1-105-003]
No FUNCTION COMMENTS
0
G3 protocol mode used
0: Standard and non-standard
1: Standard only
Change this bit to 1 only when the other end can only
communicate with machines that send T.30-standard
frames only.
1: Disables NSF/NSS signals (these are used in non-
standard mode communication)
1-6 Not used Do not change the settings.
5. Appendix: Fax Service Program
226
To Next Page
Loading...
