4-5
DTMF/DP fixed detection method selection for remote
switching
•
Bit4: 0 / Bit5: 0 = Simultaneous detection of
DTMF+PSTN external line choice
• Bit4: 0 / Bit5: 1 = DTMF fixed
• Bit4: 1 / Bit5: 0 = DP (10PPS) fixed
• Bit4: 1 / Bit5: 1 = DP(20PPS) fixed
Sets the signal from the handset as
a trigger for remote switching
6-7 Not used Do not change the settings
G3 Switch 0D Not used (do not change the settings).
G3 Switch 0E [SP No 1-105-015]
0-7
Set CNG send time interval
Some machines on the receiving side may not be able to automatically switch the 3-second
CNG interval.
High order bit
3000-2250ms: 3000-50xNms
3000 – 50 x Nms 0F (3000 ms) < N < FF (2250 ms)
Low order bit
00-0E(3000-3700ms: 3000+50xNms
3000 – 50 x Nms 0F (3000 ms) < N < 0F (3700 ms)
G3 Switch 0F [SP No. 1-105-016]
No FUNCTION COMMENTS
0
Alarm when an error occurred in
Phase C or later
0: Disabled
1: Enabled
If the customer wants to hear an alarm after each error
communication, change this bit to “1”.
1
Alarm when the handset is off-
hook at the end of communication
0: Disabled
1: Enabled
If the customer wants to hear an alarm if the handset is
off-hook at the end of fax communication, change this bit
to “1”.
2-3 Not used Do not change the settings.
Bit Switches
235
To Next Page
Loading...
