ITU-T T1 time (for PSTN G3 mode)
If the connection time to a particular terminal is longer than the NCU parameter setting, adjust this
byte. The T1 time is the value stored in this byte (in hex code), multiplied by 1 second.
Range:
0 to 120 s (00h to 78h)
FFh - The local NCU parameter factory setting is used.
Do not program a value between 79h and FEh.
Switch 01
No FUNCTION COMMENTS
0-4
Tx level If communication with a particular
remote terminal often contains errors,
the signal level may be inappropriate.
Adjust the Tx level for communications
with that terminal until the results are
better.
If the setting is "Disabled", the NCU
parameter 01 setting is used.
• Do not use settings other than
listed on the left.
Bit4 Bit3 Bit2 Bit1 Bit0
0 0 0 0 0 0
0 1 0 0 0 –8
0 1 1 1 1 –15
1 1 1 1 1 Disabled
5. Appendix: Fax Service Program
260
To Next Page
Loading...
