28. Attach the grounding wire (Long) [23] ( x 1, Washer x1, Spring washer x1).
29. Attach the grounding wire (Short) between [24] to [25] through the hole. ( x 2, Washer x2,
Spring washer x2).
30. Attach three of the clamps (Mid) [26] [27] [28].
31. Attach the clamp (Mid) [29] [30].
32. Connect the heater harness (Long) to the heater harness (Mid).
33. Attach the heater harness through the clamps as shown.
• Be sure to make the bind attached on the heater harness upper than the clamp (Mid) [29] [30].
34. Remove the drawer from the lower paper tray unit.
35. Attach the caution decal [31] in the bottom of the lower paper tray unit as shown.
36. Reassemble the copier.
Paper Tray Unit Heater
55
To Next Page
Loading...
