• Fit the oil supply pad and soak it with
silicon oil so its surface is coated
sufficiently. If coating is not sufficient, the
fusing roller will be damaged.
• Clean the oil pan using a dry cloth every
200K copies. At the same time, check the
oil hoses, drains in the oil pan, oil exit from
the unit, and oil receiver of the main body
side to make sure that the oil passes
through smoothly.
• If inside of the oil tube going to the oil tank
(P/N- A0284904) becomes very dirty, the
tube might clog and oil might overflow from
the oil receiver. If the oil does not pass
through smoothly, replace the tube with a
new one. At the same time, clean or replace
the oil tank with a new one to prevent dirty
oil from generating circulating. If paper
generating a lot of paper dust is used,
replace the tube and oil tank every 1,000K
copies.
Oil supply pad
Oil pan
Oil drain
Oil exit
Oil receiver
To Next Page