Item Description Setting Method
(6) Disable display Delete unused functions on request from
user.
Functions that can be deleted:
Margin adjustment
Duplex
Magnification
Initial setting:
All OFF (all functions effective)
Press [Margin
Adj.]/[Duplex]/[Reduce/Enlarge].
(7) Disable unit Temporarily isolate a defective unit from
the machine to prevent disability of the
whole system when an SC code lights or
paper misfeeds occur.
Initial setting: All units can be used.
Press [7] of the menu of the user tools.
⇓
Select "Tray 1/Tray 2/Tray 3/Tray 4/
Finisher/RDH/Duplex".
Try to isolate the units as follows:
Duplex: SC70, SC71, or frequent
misfeeds
RDH: SC33, 34, 35, 84, 85 or
frequent misfeeds
Tray 1: SC60 or frequent misfeeds
Tray 2: SC61 or frequent misfeeds
Tray 3: SC62 or frequent misfeeds
Tray 4: SC63, SC64, or frequent
misfeeds
Finisher: SC93, 94, 95, 96, 97, or
frequent misfeeds
(8) Select special tray The Tray 1 can be set as the special tray
for cover sheets.
One of the Tray 1, 2, and 3 can be set as
the special tray for slip sheets.
*The paper tray set as the cover sheet or
slip sheet tray is not intended for:
1) Auto tray switching mode
2)APS (Auto Paper Selection) mode
3) Tray selection by the user program
*When set as the cover sheet or slip
sheet tray, "SP." will be shown on the
paper tray key on the operation display
for identification.
Initial setting: No cover sheet and slip
sheet trays set.
Press [8] of the menu of the user tools.
⇓
Press key(s) of the tray(s) to be set as
the cover sheet tray and/or slip sheet tray.
1 July 1994 TABLE OF USER TOOLS
6-3
To Next Page