Item Description Setting Method
1-02 Service access code Change the service tool access number.
* This number is used to access the
service tools.
* To use the changed number, DIP
switch 101-1 on the main control board
must be on. To use the original number
"99900", DIP switch 101-2 must be on.
* Set the lower two figure of 5-figure code
number beginning with 999. The third
figure and onwards cannot be changed.
Initial setting: 99900
Press [1-02] of system set-up menu.
⇓
Input one or two figure value from the
key pad. (The third figure and onward are
ineffective.)
⇓
Press the Enter [#] key.
* If only one figure is input, the code
number is 9990x.
* Use Clear/Stop key to change the
entered number.
* When the Enter key [#] is not pressed,
previous data are effective.
1-03 Service telephone number Enter the telephone number that will be
showed on the guidance display with an
SC code to make contact with a service
representative.
* The maximum number of digits is 19,
including hyphens.
Initial setting: All digits 0
Press [1-03] of system set-up menu.
⇓
Press Clear key.
⇓
Input the value in the cursor position from
the key pad. (Put [-] key between office
numbers.)
⇓
Press the Enter [#] key
* Use Clear/Stop key to change the
number.
* When the Enter [#] key is not pressed,
previous data are effective.
1-04 Disable display (1) When the non-key operator screen is
selected, display or erase of "100 %"
meaning the full size mode is selected.
(2) When APS mode is selected, display
or erase of the paper table keys is
selected.
(3) When ADS mode is selected, display
or erase of the manual density change
keys is selected.
Initial setting: "Don’t Display" are
selected for all items.
Press [1-04] of the system set-up menu.
⇓
Select "Don’t Display/Display" for each
item.
1-05 Weekly timer This function is set with user tool [12].
1-06 Toner supply amount Toner supply amount is changed in four
steps (15 %, 30 %, 45 %, 60 %).
Initial setting: 30 %
Press [1-06] of the system set-up menu.
⇓
Select one of each %.
1-07 Charge wire cleaning Automatic charge and grid wires cleaning
mode ON or OFF is selected.
* Cleaner ON timing: When power is
turned on by the main switch or weekly
timer after 20,000 copies.
Initial setting: Automatic cleaning is
selected.
Press [1-07] of the system set-up menu.
⇓
Select "Yes (Auto-cleaner ON)/No
(Auto-cleaner OFF)".
1-08 Option installation Set system composition condition when
the machine is installed.
System to be set:
Tray 4 (LCT)
Finisher
Key Counter
Initial setting:
All system setting OFF
Press [1-08] of the system set-up menu.
⇓
Press [Tray 4]/[Finisher]/[Key Counter]
System Set-up 1 July 1994
7-2
To Next Page