Item Description Setting Method
2-15 Set exit tray copy limit Select number of copies fed out into the
copy tray on the main body.
* When copies are continuously made
using the copy tray, the copying
automatically stops after the selected
number of copies are made.
Initial setting: 300
Press [2-15] of the user functions menu.
⇓
Select "300/350/400/No (no limit)".
2-16 Set initial display The initial modes of the operation display
can be selected.
* The operation display returns its initial
screen in the cases below:
. When the machine is powered on
. When the clear mode key is pressed
. When the auto reset mode works
Modes that can be set
* Display type (Key operator screen/Free
operator screen)
* Auto paper tray shift (When the first
priority paper tray has no paper, the
paper tray that has paper is automatically
selected a few seconds after the
machine goes into copy stand-by
condition. This is not done when the APS
mode is selected as initial display.)
* Set copy number
* Paper tray (Including APS. The special
tray is not included.)
NOTE: When the APS is selected as an
initial mode, the paper tray that was
selected before accessing the service
tool becomes the second priority tray.
The second priority tray will be selected
when the APS mode is canceled by
raising the ADF or by pressing the APS
key again.
* Image density level (Including AID)
* Sorter
* Margin adjustment
* Duplex
* Magnification (except AMS)
Initial setting:
* Free operator screen
* Auto paper tray shift ON
* Set copy number 1
* APS
* ADS
* Finishing OFF
* Margin adjustment OFF
* Duplex OFF
* Magnification OFF (Full size)
Press [2-16] of the user functions menu.
⇓
Select "Key operator (screen)/Operator
(free operator screen)" and/or "Yes (auto
paper tray shift)/No".
⇓
Press the Enter [#] key.
⇓ (Screen will change)
Select each mode.
⇓
Press the Enter [#] key
1 July 1994 User Functions
7-9
To Next Page
Loading...
