Ricoh FT9101 - Page 231

Item Description Setting Method
2-13 Auto reset, auto OFF Select time for the auto reset and auto off
modes.
1) Auto reset mode
Automatically returns the operation panel
display to the standard mode selected by
service tool [2-16] after a fixed time.
Modes to be set:
. Set copy number
. Counted copy (or original) number
. Paper tray (including APS)
. Magnification (including AMS)
. Duplex
. Margin adjustment
. Image density level (including AID)
. Finishing
. Interrupt mode (returns to the mode
prior to interrupt)
* Auto reset mode does not work under
the following conditions:
. Start key red (Non copy stand-by)
. Paper in duplex tray
. Paper in sorter bin
. During job recovery
. During operation of user tools or service
tools
2) Auto off mode
Automatically powers off the machine in
fixed time after the machine is
temporarily powered ON during the
machine OFF time by the weekly timer.
* Auto off mode does not work under the
following condition:
. During the machine ON time by weekly
timer
. Start key red (non copy stand-by)
. During job recovery mode
. During user tools mode or service tools
mode
* When the machine ON time of the
weekly timer is reached before the auto
off time, priority is given to the machine
ON mode and the auto off mode is
canceled.
Initial setting:
Auto reset mode: One minute
Auto off mode: 30 minutes
Press [2-13] of the user functions menu.
⇓
Select "5 sec./1 min./3 min./ ∞ (no auto
reset mode)" for the auto reset mode,
and/or "30 min./1 hr./3 hr./ ∞ (no auto off
mode)" for the auto off mode.
2-14 Key tone Buzzer sound loudness and pitch at the
key ON can be selected.
* Type of buzzer sound:
. When any key (except Start key) is
pressed. (Sounds once)
. When the machine goes into stand-by
condition. Start key turns green. (Sounds
three times)
. When an input signal exists in the I/O
test mode. (Continuously sounds)
* Buzzer sound for the copy stand-by and
warning is effective even with the sound
OFF set.
Initial setting:
Loudness: Normal
Pitch: 3
Press [2-14] of the users functions menu.
⇓
Select "Off/Low/Normal/High" for the
sound loudness, and/or "1/2/3/4/5" for
the sound pitch.
User Functions 1 July 1994
7-8