Item Description Setting Method
2-09 3-side full image The 3-side full image mode can be set.
* In this mode, each of two eraser LED’s
on both edges will turn off from the
normal side erase width.
* The 3-side full image mode key will be
made effective by setting the 3-side full
image mode in user tool [10] or service
tool utility (4-05) 7-5-0. In that case, the
3-side full mode is automatically selected
at power ON when the 3-side full image
mode is selected in this screen.
* The 3-side full image mode is not
effective when the ADF stays open and
copied.
Initial setting: The 3-side full image
mode is not selected.
Press [2-09] of the user functions menu.
⇓
Select "Yes (3-side full image mode)/No
(normal erase mode)".
2-10 Auto tray switching The auto tray switching mode can be set.
* In this mode, when paper runs out
during copying, the paper tray that has
the same size paper as used in the
previous paper tray is automatically
selected without stopping the copy job.
* Paper tray priority order in selection:
No LCT:
Tray 2 → Tray 3
LCT available:
LCT → Tray 2 → Tray 3
* The Tray 1 and the paper tray set as
the special tray by service tool [2-12] is
not intended for the auto tray switching
mode.
* This function is the same as the
function in user tool [10].
Initial setting: The auto tray switching
mode is selected.
Press [2-10] of the user functions menu.
⇓
Select "Yes (auto tray switching)/No".
2-11 Original count display The number of originals copied in ADF
mode can be displayed in the message
area after copying.
* In the 2-sided original mode (2-sided
original to 2-sided copy or 2-side to
single side), the original count doubles.
* The original count display is cleared by
the auto reset mode or by pressing any
key.
* When one copy is made from an
original, the original count is not
displayed.
* This function is the same as the
function in user tool [10].
Initial setting:
No original count display
Press [2-11] of the user functions menu.
⇓
Select "Yes (original count display)/No".
2-12 Set special paper tray Each paper tray can be set as a special
tray.
* The paper tray set as the special tray is
not intended for:
1) Auto tray switching mode
2) APS (Auto Paper Selection) mode
3) Tray selection by the user program
Set the special tray when there is the
paper tray that does not allow the
functions above. For example, when
color paper is used in a paper tray, the
tray should not be intended for the
limitless paper feed mode.
* When set as the special tray, a small
red circle will be shown on the paper tray
key on the operation display for
identification.
Initial setting: No special tray set
Press [2-12] of the user functions menu.
⇓
Press key(s) of the tray(s) to be set as
the special tray(s).
1 July 1994 User Functions
7-7
To Next Page