Ricoh FT9101 - Page 249

Initial Setting Table
Mode No. Set No. Mode Name Initial Setting for Each Mode No.
1 10 Disables Paper Near-end Indication 0
12 Clears All Stored User Programs
2 10 Duplex Speed-up Mode 10
3 8 Paper Size Erase Mode 0
4 1 Original Tray Exit Mode 0
5 0 SADF 50 cpm 0
1 SADF 34 cpm
2 SADF 25 cpm
3 SADF 20 cpm
Mode No.
(6 to 14)
Setting of
Mode No. 5
Mode Name Initial Setting for Each Mode No.
6
0 to 7
Automatic Sort Selection OFF
7 No Erase Copy Mode OFF
8 Not used Must be OFF
9 Not used Must be OFF
10 Not used Must be OFF
11 Not used Not valid
12 not used Must be OFF
13 Margin Adjustment Present Memory OFF
14 Not used Must be OFF
6
8
Fusing Jam Indication OFF
7 Automatic APS Selection ON
8 Not used Must be OFF
9 Not used Must be OFF
10 Disable Flash Life Notice OFF
11 Fusing Rush Current Prevention ON
12 Not used Not valid
13 Not used Must be OFF
14 Valid Pre-heat Key OFF
6
9
A3 Double Copy Count OFF:Double Count Mode
7 Not used Not valid
8 Duplex Tray Maximum Limit OFF: 40 (A3)/80(A4)
9 Not used Not valid
10 Valid 81/2"x13" key ON
11 Not used Must be OFF
12 Disable Cover/Chaptering Modes OFF
13 Stapling with Stack mode OFF
14 Not used Not valid
6
10
Automatic Staple Mode Selection OFF
7 Reverse Back Cover Sheet ON
8 Copy onto Slip Sheet ON
9 Manual Staple Mode OFF
10 Not used Must be OFF
11 Automatic Paper Feed Out in Manual
Staple Mode
OFF
12 Not used Must be OFF
13 Automatic Accounting Mode Selection by
Auto Reset
OFF
14 Not used Must be OFF
Utility Modes 1 July 1994
7-26