10-5-8: Disable flash life notice
Disables the message indicating the flash lamp’s end of life (the notice of SC#17).
10-5-9: Valid 8 1/2"x13" Key
The 81/2"x13" and A4 keys are displayed in user tool [3] to select original and copy paper sizes.
11-5-8: Fusing rush current prevention
Rush current from the wall outlet is absorbed to prevent the circuit breaker for the wall outlet from
being blown. This must be always ON.
11-5-10: Automatic paper feed out in manual staple mode
While copies are made in the manual staple mode, when this mode is selected and the number of
copies stacked in the staple tray of the finisher exceeds the stack capacity set with service tool
[2-07], the copies are automatically fed out from the jogger tray.
12-5-9: Disable cover/chaptering modes
The special features (cover/chaptering modes) are disabled.
13-5-0: Margin adjustment present memory
The present value of the margin adjustment mode is put in memory. As the value in memory is
cleared by pressing the Clear Modes key or by the auto mode clear function, the auto mode clear
function must be canceled using service tool [2-13].
13-5-9: Stapling with stack mode
Stapling with the stack mode is available.
13-5-10: Automatic accounting mode selection by auto reset
When security or normal accounting mode is selected with service tool [2-08], the copier
automatically leaves the copy mode and requires a user access code after the period set with
service tool [2-13].
14-5-8: Valid pre-heat key
By holding on the Clear Modes key for a while, all displays on the operation unit turn off.
1 July 1994 Utility Modes
7-25
To Next Page
Loading...
