6-5-0: Automatic sort selection
The machine automatically selects the shift tray ON mode when 2 or more for the copy set number
is entered in the ADF mode.
NOTE
At this mode, set originals in the ADF first and enter a copy set number so as not to select the shift
tray ON mode.
6-5-8: Fusing jam indication
When a paper jam occurs, jam location indicators C and D (fusing jam) are always lit. This is to
direct the operator to remove paper in the fusing unit. On some types of paper, it may be difficult to
feed out paper stopped in the fusing unit by the job recovery mode.
6-5-9: A3 double copy count
The mechanical copy counter (also the user code counter in user tool [9] if it is used) counts up 2
when an A3 or 11"x17" size copy is made.
6-5-10: Automatic staple mode selection
Users can select to have the auto staple mode (1 upper staple) or shift tray ON mode selected
when the Finishing key in the free operator screen is selected.
7-5-0: 3-side full image mode
Copies with no erase margin can be made. (The leading edge erase margin is as in the normal
copy mode.) A new key, beside the Check modes key, to select the 3-side full image or normal
copy can be used.
NOTE:
• The 3-side full image mode is automatically selected at power ON when service tool 2-09 is set.
• This function is the same as the function in user tool [10].
7-5-8: Automatic APS selection
When originals are set in the ADF, the automatic paper selection mode is selected if a paper tray
has been selected.
7-5-10: Reverse back cover sheet
This mode is the same as that in the user tool [10] "User Utility."
8-5-9: Duplex tray maximum limit
The maximum number of copies stacked in the duplex tray can be changed. ON: 50 for A3, B4,
11"x17", and 81/2x14" and 100 for A4, B5, 81/2"x11", and 8"1/2x13". OFF: 40/80.
8-5-10: Copy onto slip sheet
This mode is the same as that in the user tool [10] "User Utility."
9-5-10: Manual staple mode
Enables the use of the manual staple mode when originals are set in the single original feed mode
or on the exposure glass. For understanding how to use the manual staple mode, refer to the
operating instructions.
Utility Modes 1 July 1994
7-24
To Next Page
Loading...
