1-10: Disables paper near-end indication
1-12: Clears all stored user programs
To clear the programs, the "0" key must be pressed after setting this mode.
2-10: Duplex speed-up mode
When the stack mode is selected with user tool 10 and one is entered for the copy set number in
the 2-sided copies from 2-sided original or single sided original mode (duplex mode), originals are
copied as follows:
The originals in ADF are fed twice. At the first feed, the even numbered originals are copied. The
copies are stacked in the duplex tray. The originals are continuously fed again and the odd
numbers are copied on the back side of the copies from the duplex tray. This makes copying faster
than in normal mode. If this mode is not selected, originals are copied as in the usual stack mode
even in the above copy mode.
3-8: Paper size erase mode
The machine selects the erase margins using the paper size to be copied, even in the ADF/SADF
modes. User program number 10 must be pressed when using this mode.
NOTE
Normally, the original size is used for erasing in the ADF/SADF modes. For example, when a
computer feed form is copied on A4 size paper using the SADF and reduction modes, the machine
takes the original size B4 size. This is because only the original width is detected in the SADF mode
and the width of a computer feed form is close to that of B4 paper. As a result, the trailing part of the
original is erased and does not appear on the copy. In such a case, set this mode and select the
number 10 key of the user program mode before a copy is made. Since the erase margins are
matched with the paper size (A4 size in this case), the whole image of the computer feed form is
copied.
4-1: Original tray exit mode
In the ADF mode originals do not return to the original table, but fed out to the original table used in
the SADF mode. The originals are fed out without the reversing motion. This mode is not used with
the duplex and/or sort mode. When the original tray exit mode is selected, the duplex mode is
canceled and the stack mode is selected automatically. A new key, beside the Check mode key, to
select this function can be used. The position of the original stopper on the original table must be
correctly adjusted to the original width to use this mode.
NOTE
• When paper with holes is used as originals, the holes tend to be caught by the reverse junction pawls
and this makes an original jam. To prevent such case, this mode can be used.
• This mode can be set as an initial selection at power on. First, select this mode. Then, access service
tool [2-16] and press the Enter [#] key twice.
• This function is the same as the function in user tool [10].
5-0: SADF 50 cpm (Initial setting)
5-1: SADF 34 cpm
5-2: SADF 25 cpm
5-3: SADF 20 cpm
Changes the copying speed in the SADF mode. The operator can select the most suitable timing of
the SADF original feed to make the job faster.
1 July 1994 Utility Modes
7-23
To Next Page
Loading...
