6. Stick the cushion (accessory) on the left side of the
finisher as shown.
7. Open the finisher and inverter front doors. Then
remove the linking stay access hole cover (2
screws).
8. Be sure that the linking stay of the finisher is in the
lock position. Align the docking pins with the
linking holes of the finisher, and press the finisher
until the docking pins click. Reinstall the linking
stay access hole cover.
9. Install the finisher shift tray with four M4 x 8 plated
panhead screws (accessories).
10. Open the finisher front door and install the staple
cartridge (refer to the instruction decal on the rear
side of the front door):
a) Pull out the staple unit.
b) Release the lock lever and turn the
stapler counterclockwise until it locks.
c) Remove the green plastic clip from the
staple cartridge, and install the cartridge
in the stapler.
d) Set the stapler to its original position.
e) Push the staple unit in its original posi
tion.
Cushion
0 to 2 mm
5 to 10 mm
Linking stay
Shift tray
Cover
Green
plastic
clip
Lock lever
Staple unit
To Next Page
Loading...
