Ricoh IM C2000 Series User Manual

Placing an Original on the Exposure Glass
Use the exposure glass to scan originals that cannot be placed in the auto document feeder (ADF), such
as books and license cards.
• When lowering the ADF, do not place your hands on the hinges and exposure glass. Your
hands or fingers are caught, which can result in injury.
• Do not lift the ADF forcefully. The cover of the ADF might open and cause injury. The ADF, or its
hinges may also become damaged.
1. Lift the ADF.
Lift the ADF by more than 30 degrees to detect the document size automatically when placing an
original on the exposure glass.
2. Place the original face down and aligned to the mark on the upper left corner of the scan
area.
DZW102
page 212 "Recommended Original Size and Weight"
page 214 "Sizes Detectable with Auto Paper Select"
3. Lower the ADF.
• When you place a thick book or three-dimensional original on the exposure glass and lower the
ADF, the back side of the ADF rises up to accommodate the original.
1. Getting Started
58

Ricoh IM C2000 Series Specifications

General

Print Resolution	1200 x 1200 dpi
Maximum Paper Capacity	2, 300 sheets
Duplex Printing	Yes
Standard Memory	2 GB
Power Consumption (Maximum)	1.3 kW
Copy Speed (Color)	20 cpm
Copy Speed (Mono)	20 cpm
Copy Resolution	600 x 600 dpi
Print Speed	20 ppm
Scan Resolution	600 dpi
Connectivity	USB, Ethernet, Wi-Fi
First Print Time (Color)	7.5 seconds or less
Supported Paper Sizes	A3, A4, A5, B4, B5
Paper Weight	52 - 300 gsm
Hard Disk Drive	320 GB
Power Source	50/60Hz
Fax Resolution	200 x 200 dpi