Message Cause Solution and reference
"Paper size and/or
type mismatched or
no ppr. in Bypass
Tray."
The paper size or
paper type
specified in the
printer driver does
not match the
paper settings, in
the machine, for
the bypass tray.
Specify [Driver / Command] in [Settings] [Tray/Paper
Settings] [Printer] [Tray Setting Priority] [Bypass
Tray].
"Paper size and
type are
mismatched. Select
another tray from
the following and
press [Continue].
To cancel job,
press [Job Reset].
Paper size and
type can also be
changed in User
Tools."
The paper tray
loaded with paper
of the size or type
specified in the
printer driver is not
available.
• To proceed with printing after changing the paper
setting, select a tray and press [Continue]. When
Staple, Cover Sheet, Slip Sheet, Chaptering, or
Designate is specified, or when Duplex printing is
specified on a paper tray that does not support the
function, printing cannot be performed. When Sort is
specified, only one copy of the document is printed.
• To proceed with printing on the specified paper,
load the paper and then check that the paper size
and type are correctly specified in [Settings]
[Tray/Paper Settings].
page 175 "Loading Paper into the Paper Tray"
"Parallel I/F board
has a problem."
An error has
occurred in the
parallel interface.
Turn off the power of the machine, wait for 10 seconds or
more after confirming that the main power indicator is
turned off, and then turn on the power.
page 13 "Turning On and Off the Power"
If the message persists even after you have turned the
power off and then on, consider repairing the machine.
"Printer font error." There is a problem
in the font file of
the machine.
Consider repairing the machine.
"Print overrun." A page image is
discarded while
printing the page.
Decrease [Resolution] in the printer driver.
See "Applying Different Print Settings Depending on the
Document Type", User Guide (Full Version).
When a Message Appears While Using the Printer Function
287
To Next Page
Loading...
