Ricoh M065 - When Installing the New BCU

Electrical Components
M065/M066 4-146 SM
When installing the new BCU
 Make sure you print out the SMC reports ("SP Mode Data" and "Logging Data")
before you replace the NVRAM.
 Keep NVRAM away from any objects that can cause static electricity. Static
electricity can damage NVRAM data.
1. Remove the NVRAM from the old BCU.
2. Install the NVRAM on the new BCU after you replace the BCU.
 Make sure the NVRAM is correctly installed on the BCU. Insert the NVRAM in
the NVRAM slot with the "half-moon" pointing [A] to the downward side.
3. Reassemble the machine.
4. Turn on the main power of the machine.
5. "SC995-01" occurs.
6. Enter the serial number with SP5811-004.
7. Turn the main power of the machine off and on.