Ricoh M065 - For Installing the Securing Bracket

Tray Heater
M065/M066 2-38 SM
16. Attach the on/standby decal [A] to the left-hand side of the main power switch.
 You can adjust the tray heater switch setting with SP5805-001 as shown below.
 0: Default setting. The heater is on when the main switch is off or when the
machine is in energy saver mode.
 1: The heater is always on.
For Installing the Securing Bracket
 The securing bracket must be installed when the tray heater is installed in the
machine with the paper feed unit (M384).
1. Remove the holder (
p.2-19 "Caster Table (M393)").
2. Reinstall the inner left lower cover (
x 3).
3. Close the left cover.
4. Remove the left cover of the paper feed unit (
p.2-19 "Caster Table (M393)").