Printer Installation
SM 2-13 M065/M066
Installation
Printing the Test Page
You can check if the printer works correctly by printing a test page such as the
configuration page. However, you cannot check the connection between the printer and the
computer by printing the test page.
1. Turn on the power switch of the printer.
"Ready" shows on the panel display after the machine warms up.
2. Press the "Menu" key.
3. Press the "
" or " " key to select "List/Test Print".
4. Press the "OK" key.
5. Press the "
" or " " key to select "Config. Page".
6. Press the "OK" key.
7. The test printing starts shortly after.
8. Press the "Menu" key to return to the initial screen.
9. Turn off the power switch of the printer.
Settings Relevant to the Service Contract
Change the necessary settings depending on the each customer's service contract. For
details, refer to "Meter Click Charge" following this section.
2.3.2 METER CLICK CHARGE
Basically, there are two ways to set up this function.
Meter click charge enabled (SP 5-930-001 set to "1 (enabled)"): The counter can be
displayed and printed by the customer. The technician can then call the customer and ask
them to read the counter.
Meter click charge disabled (SP 5-930-001 set to "0 (disabled)"; this is the default
setting): The counter cannot be displayed or printed by the customer. To check the counter,
the technician must print the SMC report (SP 5-990).
You must select one of the counter methods (developments/prints) in accordance
with the contract (
SP5-045-001).
If the setting of SP5-930-001 is set to "1 (enabled)", the settings of SP5-930-010,
-014 and -016 must be adjusted.
To Next Page
Loading...
