System Service Mode
SM Appendix 8-29 M065/M066
Appendix:
SP Mode
Tables
SP2-XXX (Drum)
2005
[Charge DC V:Fixed] DFU
(Paper Type, Process Speed, Color)
Paper Type –> Plain, Thick 1, Thick 2
Adjusts the DC component of the charge roller bias in the various print modes.
Charge bias (DC component) is automatically adjusted during process control;
therefore, adjusting these settings does not effect while process control mode
(SP3-041-1 Default: ON) is activated. When deactivating process control mode
with SP3-041-1, the values in these SP modes are used for printing.
001 Plain: Bk *ENG
[0 to 1000 / 600 / 10 –V/step]
002 Plain: C *ENG
003 Plain: M *ENG
004 Plain: Y *ENG
2006
[Charge DC V:Fixed] DFU
(Paper Type, Process Speed, Color)
Paper Type –> Plain, Thick 1, Thick 2
Adjusts the AC component of the charge roller bias in the various print modes.
Charge bias (AC component) is adjusted by environment correction
(SP2-007-xxx to SP2-011-xxx). These SPs are activated only when SP2-012-1
is set to "1: manual control".
001 Plain: Bk *ENG
[0 to 3000 / 2100 / 10V/step]
002 Plain: C *ENG
003 Plain: M *ENG
004 Plain: Y *ENG
To Next Page
Loading...
