Ricoh M065 - Page 438

System Service Mode
M065/M066 8-28 SM Appendix
Plain
032 Tray2,3,4: Feed-STM ON: Plain *ENG
033
Tray2,3,4: Feed-Solenoid ON:
Thick
*ENG
[-10 to 25 / 0/ 2.5 mm/step]
034
Tray2,3,4: Feed-Solenoid OFF:
Thick
*ENG
[-10 to 10 / 0/ 1 mm/step]
035
Tray2,3,4: Feed- Clutch OFF:
Thick
*ENG
036 Tray2,3,4: Feed-STM ON: Thick *ENG
037 Tray2,3,4: Feed-ON: High-Middle *ENG
[0 to 10 / 0/ 0.5 mm/step]
038 Tray2,3,4: Feed-ON: Low *ENG
1950
[Fan Cool Timeset]
Adjust the rotation time for each fan motor after a job end.
001 Development Fan *ENG
[0 to 600 / 0/ 1 sec/step]
002 Development Fan2 *ENG
003 Imaging Fan (Laser Unit Fan) *ENG
004 Fusing Exit Fan1 *ENG
005 Fusing Exit Fan2 *ENG
006 PSU Fan *ENG
007 P_Toner_Fan (Toner Supply Fan) *ENG
008 Image Form Fan (Drive Unit Fan) *ENG
009 P_FUSNS (Fusing Cooling Fan) *ENG