Ricoh M065 - Page 268

Using the Debug Log
M065/M066 5-18 SM
1 Engine SC Error
Saves data when an engine-related SC code
is generated.
2 Controller SC Error
Saves debug data when a controller-related
SC Code is generated.
3 Any SC Error
Saves data only for the SC code that you
specify by entering code number.
4 Jam Saves data for jams.
 More than one event can be selected.
 Example 1: To Select Items 1, 2, 4
 Push the
or key to select the appropriate items(s). Press the "OK" key
for each selection. This example shows "Engine SC Error" selected.
 Example 2: To Specify an SC Code
 Push the
or key to select "3 Any SC Error", enter the 3-digit SC code
number with the
or key. Then press"OK" key. This example shows an
entry for SC670.
 For details about SC code numbers, please refer to the SC tables in Chpater 4.
"Troubleshooting".
6. Select one or more memory modules for reading and recording debug information.
Select "SP5859".
Under "5859" press the necessary key item for the module that you want to record.
Enter the appropriate 4-digit number with the
or key. Then press"OK".
 Refer to the two tables below for the 4-digit numbers to enter for each key.
The following keys can be set with the corresponding numbers. (The initials in parentheses
indicate the names of the modules.)