Ricoh M065 - Page 338

SC Tables
M065/M066 3-28 SM Appendix
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
540 D
Fusing/Paper exit motor error
The BCU receives the lock signal 2.0 seconds after turning on the
fusing/paper exit motor.
 Motor overload
 Defective fusing/paper exit motor
 Defective or disconnected connection for the fusing/paper exit
motor
1. Replace the fusing/paper exit motor.
2. Check or replace connector and harness for the fusing/paper exit
motor.
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
541 A
Heating roller thermopile error
The temperature measured by the heating roller thermopile does not
reach 0°C for 6 seconds.
 Loose connection of the heating roller thermopile
 Defective heating roller thermopile
 Defective thermopile
1. Check if the heating roller thermopile is firmly connected.
2. Replace the heating roller thermopile.