Ricoh MP 2014AD - Page 209

SC Code Descriptions
SM 6-11 D245/D246/D247
Troubleshooting
SC No. Level Error Name/Error Condition/Major Cause/Solution
 ID sensor defective
 ID sensor harness damaged.
 ID sensor not connected correctly.
 MPU defective
 Laser unit defective
 Imaging density fault
 HVPS board defective
 ID sensor dirt
 Clean the ID sensor.
 Replace the ID sensor.
 Replace and reset the ID sensor harness.
 Replace the MPU.
 Replace the HVPS board.
SC No. Level Error Name/Error Condition/Major Cause/Solution
354-00 B ID sensor: Auto adjustment timeout error (detailed)
If Vsg is not automatically adjusted to 4.0±0.2 V twice
consecutively when the ID sensor is adjusting Vsg automatically,
this SC is issued (only when the SP5-995-001 is set to “1”).
 ID sensor defective
 ID sensor harness damaged.
 ID sensor not connected correctly.
 MPU defective
 Laser unit defective
 Imaging density fault
 HVPS board defective
 ID sensor dirt
 Clean the ID sensor.
 Replace the ID sensor.
 Replace and reset the ID sensor harness.
 Replace the MPU.
 Replace the HVPS board.