Ricoh Pro 8320 - Ring Binder: Alignment Pin Error; Sc756-42

1.SC Codes
570
SC756-42
Error Name
Ring Binder: Alignment Pin Error
Pattern
B
Error Condition
 The alignment pin moved from home position, but home position is detected even after a specified
time had passed. (The first time is reported as a jam. An SC is issued the second time this occurs.)
 The alignment pin has moved to the home position, but home position is not be detected within a
specified time. (The first time is reported as a jam. An SC is issued the second time this occurs.)
 *First time jam: Alignment pin motor jam (J342) or Alignment unit jam (J344)
Major Cause
 Power of downstream unit not turned on
 Alignment pin motor defective
 Connector disconnected
 Overload
 Alignment pin HP sensor defective
Solution
1. Turn the power OFF and ON.
2. Check the connector.
Check connection between the alignment pin motor/ alignment pin HP sensor and the sub board.
(Check all the connectors are completely connected.)
If the connector is disconnected, reconnect the connector. Turn the power OFF/ON, and then
check if the SC recurs.
3. Check the harness.
Check if the harness between the alignment pin motor/ alignment pin HP sensor and the sub board
is damaged or exposed. If so, replace the harness. Turn the power OFF/ON, and then check if the
SC recurs.
4. Replace the components.
 Replace the alignment pin motor.
 Replace the alignment pin HP sensor.
 Replace the sub board.