Ricoh Pro 8320 - One Sheet Pushing out Another or Sheets Becoming Crimped; Trailing Edge of Stapled Sheets Close to the Paper Exit

4.Troubleshooting for Peripheral Units
789
If the trailing edge of the paper is not pushed out completely in proof tray delivery, attach the support
tray to the proof tray.
One Sheet Pushing Out Another or Sheets Becoming Crimped
Sheets are curled downward.
 If the decurl unit is used
1. On the Adjustment Settings for Skilled Operators menu, select Machine: Paper Feed/ Output >
Adjust Paper Curl > Set to "Adjust Convex Curl". (SP 1-906-001 to 012: De-curler Setting Tray
<number> :Paper Path Selection)
2. To control the amount of curl correction, select "Weak" if the present setting is "Off" or "Strong".
3. If one sheet pushes out another sheet, set the convex curl correction (face curl) of the decurl unit to
prevent the error.
 If the decurl unit is not used
1. Remove the paper stack and turn it upside down.
2. To improve stacking, install the output jogger unit.
Trailing Edge of Stapled Sheets Close to the Paper Exit
Cause:
If the stapled sheets are curled strongly or become limp after delivery, the trailing edge of the sheets
may be too close to the paper exit when the paper is stacked.