4.Troubleshooting for Peripheral Units
834
No: Go to next step.
5. Set [0301: Correct Output Paper Curl: 1 Sided: Face Up] to [Large].
6. Print the image. Was the problem resolved?
Yes: Finish
No: Go to next step.
7. Is just the first sheet misaligned?
Yes: Finish
No: Go to next step.
8. Is it just some of the last sheets?
Yes: Finish
No: Contact your supervisor.
The top sheet of each offset bundle of delivered sheets may protrude above the rest of the
bundle by about 7 mm.
Registration, Skew Adjustment
Registration Adjustment
Disconnect the stacker from the upstream unit and do this adjustment on the left side of the
upstream unit connected to the main unit. To avoid damaging the cart set switch, be sure to
remove the Roll-away cart from inside the stacker when you disconnect the upstream unit.
If a Booklet (or Stapler) finisher is connected downstream, paper cannot be output to the proof
tray of the stacker. With a downstream finisher connected, do the adjustment after
disconnecting the I/F cable of the finisher and then turning the main machine on.
1. Load some A3 or 11”x17” paper in the 2
nd
tray of the main unit, and then output several sheets of
single-side printing to the proof tray of the stacker.
2. Watch the edge of each sheet as it exits the unit.
If the edge is within the first notch (2 mm) on the scale, there is no problem.
If the edge goes beyond the first notch, adjustment is required.
[A]: This is the rear scale for 11"×17" (DLT)
To Next Page
Loading...
