Ricoh Pro 8320 - Right Steering Plate Adjustment

5.Other Information
856
the right steering plate should not be adjusted. Leave the right steering plate at its factory
setting, and adjust the left steering plate.
Right Steering Plate Adjustment
1. Execute application of lubricant with SP2-310-001, and then do SP2-920-002 (Steering Control
Roller Stable Position of Steering Roller), and check its setting. Based on this setting, adjust the
position of the right steering plate by referring to the table below.
SP2-920-
002
From the Current Right Steering Plate Scale
Setting
Comments
+21 to +150
+1
Move to upper part of
scale
-20 to +20
No adjustment required
Within correct range
-20 to -150
-1
Move to lower part of
scale
2. Loosen (do not remove) the four screws at [A] and [B].