Problem Causes Solutions
Paper delivered to the stacker
is curled, causing it to not
align properly.
When using coated paper, it
might become curled or might
not be properly aligned when
it is delivered.
Select [Adjust Curl: Weak] or [Adjust
Curl: Strong] under [Adjust Paper
Curl] in Adjustment Settings for
Operators.
For details about the Adjustment Settings
for Operators, see General Settings
Guide, "Adjustment Settings for
Operators".
• If you cannot make prints as you want because of paper type, paper size, or paper capacity problems,
use recommended paper. See "Recommended Paper Sizes and Types", About This Machine.
• Curled paper causes misfeeds, soiled paper edges, or slipped positions while performing staple or
stack printing. When using curled paper, first straighten the curl with your hands or by placing the
paper upside down. Also, lay paper on a flat surface to prevent paper from curling, and do not lean
it against the wall.
• p.34 "When Z-folded Paper Is Not Properly Aligned"
• p.60 "Changing the Paper Size"
• p.74 "Adding Staples"
• p.85 "Removing Jammed Paper"
When You Have Problems Operating the Machine
23
To Next Page
Loading...
