Pull out the paper tray
carefully until it stops.
Remove paper if
loaded.
Remove the paper
supports.
Set the paper
supports in their
storage positions.
Make sure that the
paper supports are
properly set.
Change paper size.
Load paper into the paper
tray, and then carefully
slide the paper tray fully in.
CAL158
Fanning the Paper
This section describes how to fan a stack of paper before you load it in a paper tray.
• If you are loading coated paper in the Wide LCT, it is important that you fan the sheets thoroughly.
Misfeeds may occur if paper is not fanned thoroughly.
1. Loosen the stack by riffling the sheets.
Loading Paper
47
To Next Page
Loading...
