8. Load additional sheets, if necessary.
9. Tightly fit the end fence to the loaded paper, and then re-lock the end fence again.
10. Carefully slide the paper tray fully in.
11. Check the size on the display.
• If you load paper that cannot be automatically detected, specify its size using the display panel. For
details, see "Changing to a Size That Is Not Automatically Detected".
• p.46 " Loading small size paper into the Wide Large Capacity Tray"
• p.69 "Changing to a Size That Is Not Automatically Detected"
Loading small size paper into the Wide Large Capacity Tray
To load the Wide LCT with paper smaller than B5 JIS that has a vertical length of 139.7 to less than 257
mm (5.5 to less than 10.12 inches), the paper supports must be removed.
This section describes how to remove the paper supports.
2. Adding Paper, Toner, Staples, Rings and Glue
46
To Next Page
Loading...
