Registering the Equipment
54
4
❖ Line connection
Select “RC Gate and fax shared line” if the equipment shares the tele-
phone line with a FAX. Select “RC Gate exclusive line” if only the equip-
ment uses the connected telephone line.
Note
❒ “FAX” interface on the modem board will be enabled when “RC Gate
and fax shared line” is selected.
B Set [Pulse/Tone dialing line] and [Outside access No.].
❖ Pulse/Tone dialing line
Select your line type.
• Tone dialing phone
• Pulse dialing phone (20PPS)
• Pulse dialing phone (10PPS)
❖ Outside access No.
When the line is connected to the PBX, enter the numbers and symbols
for the external line. If the input is not required, leave it blank.
Note
❒ If a pause is needed between outside access number and the phone
number, enter a comma (,). One comma will give a pause for two sec-
onds.
K Click [Next].
Note
❒ If you click [Back] instead of [Next], entered values will be cleared and you
will return to the [RC Gate Registration Wizard: E-mail Settings] screen.
The [RC Gate Registration Wizard: Confirm Settings] screen will appear.
To Next Page
Loading...