Rigol DHO800 Series User Manual

17
Waveform Recording and Playing
Waveform recording/playing function can play the recorded waveforms, enabling you
to analyze the waveforms better.
You can enter the "Record" menu in the following ways.
• Click or tap the function navigation icon
and then select Record to enter the
"Record" menu.
• Click or tap
Record on the toolbar to enter the "Record" menu.
• Press the front-panel
key and select Record in the pop-up "Analyse"
menu to enter the "Record" menu.
Figure 17.1 "Record" Menu
TIP
When the acquisition mode is set to
UltraAcquire , the waveform recording/playing function is
not available. You can view waveform segments using
Navigate segments .
17.1 Common Settings
Waveform Recording
Click or tap the
Record on/off switch to enable or disable the waveform recording
function. Before recording the waveform, you can refer to descriptions in
Record
Options
to set the waveform recording parameters.
Waveform Recording and Playing
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved. DHO800 User Guide
187

Rigol DHO800 Series Specifications

General

Channels	2 or 4 analog channels
Vertical Resolution	12-bit
Vertical Sensitivity	1 mV/div to 10 V/div
Timebase Range	1 ns/div to 1000 s/div
Power Supply	100-240 VAC, 50/60 Hz
Waveform Capture Rate	1, 000, 000 wfm/s
Interfaces	USB Host, USB Device, LAN
Digital Channels	Optional 16-channel MSO
Protocols Decoding	I2C, SPI, UART, CAN, LIN
Input Impedance	1 MΩ
Trigger Types	Edge, Pulse, Video, Slope, Pattern, Duration, Timeout, Runt, Window