Rigol DHO800 Series User Manual

11.1.1 Measurement Settings .....................................................................................................149
11.1.2 Remove the Measurement ............................................................................................. 151
11.2 Frequency Counter .........................................................................................................................151
11.2.1 Measurement Settings .....................................................................................................152
11.2.2 Reset Statistics .................................................................................................................... 153
11.2.3 Remove the Measurement ............................................................................................. 153
12 Histogram Analysis .....................................................................................................154
12.1 To Enable or Disable the Histogram Function ......................................................................154
12.2 To Select the Histogram Type .....................................................................................................155
12.3 To Select the Histogram Source ................................................................................................ 155
12.4 To Set the Histogram Height ......................................................................................................155
12.5 To Set the Histogram Range .......................................................................................................156
12.6 Histogram Analysis Results ......................................................................................................... 156
12.7 To Remove Results ..........................................................................................................................158
12.8 To Clear Statistics ............................................................................................................................158
13 Reference Waveform ..................................................................................................159
13.1 To Enable Ref Function ................................................................................................................. 159
13.2 To Set the Reference Waveform ................................................................................................ 159
13.3 To Set the Ref Waveform Display ..............................................................................................160
13.4 Export and Import Operation .....................................................................................................161
14 Pass/Fail Test ................................................................................................................. 163
14.1 To Enable or Disable the Pass/Fail Test Function .................................................................164
14.2 To Select the Source ...................................................................................................................... 164
14.3 To Create a Mask .............................................................................................................................164
14.4 To Set the Output Form of the Test Results ...........................................................................165
14.5 To Start or Stop the Pass/Fail Test Operation ........................................................................166
14.6 To Display the Statistics of the Test Results ...........................................................................166
15 Protocol Decoding ......................................................................................................168
15.1 Parallel Decoding ............................................................................................................................168
15.1.1 Clock Setting (CLK) ............................................................................................................169
15.1.2 Bus Setting ...........................................................................................................................170
15.1.3 Display-related Settings .................................................................................................. 171
15.1.4 Event Table ...........................................................................................................................171
15.2 RS232 Decoding ..............................................................................................................................172
15.2.1 Source Setting .....................................................................................................................174
15.2.2 To Set Data Package ......................................................................................................... 175
15.2.3 Display-related Settings .................................................................................................. 175
DHO800 User Guide
IV
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.

Rigol DHO800 Series Specifications

General

Channels	2 or 4 analog channels
Vertical Resolution	12-bit
Vertical Sensitivity	1 mV/div to 10 V/div
Timebase Range	1 ns/div to 1000 s/div
Power Supply	100-240 VAC, 50/60 Hz
Waveform Capture Rate	1, 000, 000 wfm/s
Interfaces	USB Host, USB Device, LAN
Digital Channels	Optional 16-channel MSO
Protocols Decoding	I2C, SPI, UART, CAN, LIN
Input Impedance	1 MΩ
Trigger Types	Edge, Pulse, Video, Slope, Pattern, Duration, Timeout, Runt, Window