Rigol DS2302A Programming Guide

2 Command System RIGOL
MSO2000A/DS2000A Programming Guide 2-1
2 Command System
This chapter introduces the command subsystems of MSO2000A/DS2000A command set.
The topics of this chapter:
 :AUToscale
 :CLEar
 :RUN
 :STOP
 :SINGle
 :TFORce
 :TLHAlf
 IEEE 488.2 Common Commands
 :ACQuire Commands
 :BUS<n> Commands
 :CALCulate Commands
 :CALibrate Commands
 :CHANnel<n> Commands
 :CURSor Commands
 :DISPlay Commands
 :FUNCtion Commands
 :LA Commands (MSO2000A/MSO2000A-S)
 :LAN Commands
 :MASK Commands
 :MEASure Commands
 :OUTPut<n> Commands (MSO2000A-S/DS2000A-S)
 :RECall Commands
 :REFerence Commands
 :SAVE Commands
 :SOURce<n> Commands (MSO2000A-S/DS2000A-S)
 :SYSTem Commands
 :TIMebase Commands
 :TRACe<n> Commands (MSO2000A-S/DS2000A-S)
 :TRIGger Commands
 :WAVeform Commands
Note:
1. Unless otherwise noted, in this manual the introductions and parameter ranges are based on
MSO2302A-S.
2. For parameter setting commands (for example, the time, frequency and amplitude), the oscilloscope
can only accept numbers and set the parameters using the default units; it cannot recognize the
units sent with the parameters. For the default unit of each parameter, please refer to the description
in each command in the following introductions.

Rigol DS2302A Specifications

General

Brand	Rigol
Model	DS2302A
Category	Test Equipment
Language	English