Rigol DS2302A Programming Guide

2 Command System RIGOL
MSO2000A/DS2000A Programming Guide
2-3
:SINGle
Syntax
:SINGle
Description
Set the oscilloscope to single trigger mode.
Explanation
 In single trigger mode, the oscilloscope triggers once the trigger conditions are met and then stops.
 In single trigger mode, using the
:TFORce command can generate a trigger signal forcefully.
 You can use the
:RUN and :STOP command to set the oscilloscope to Auto trigger mode and STOP
state respectively.
:TFORce
Syntax
:TFORce
Description
Generate a trigger signal forcefully. The function of this command is the same as that of FORCE in the
trigger control area at the front panel.
:TLHAlf
Syntax
:TLHAlf
Description
Set the trigger level to the vertical midpoint of the trigger signal amplitude.

Rigol DS2302A Specifications

General

Brand	Rigol
Model	DS2302A
Category	Test Equipment
Language	English