Riverbed SteelFusion Edge 2200 - Page 32

32 SteelFusion Edge Hardware and Maintenance Guide
Installing Network Interface Cards in SteelFusion Edge Appliances Supported NICs for SteelFusion Edge appliances
Note: The dual 10-GbE SFP+ card requires the SteelFusion Edge 4.2 software version or later. All other NICs require
SteelFusion Edge 4.0 or later.
Two-port 40-GbE multimode
(fiber)
NIC-1-040G-2SR4-BP Not supported Slot 3 RiOS
Not supported Hypervisor
Two-port 40-GbE multimode
(fiber)
NIC-1-040G-2LR4-BP Not supported Slot 3 RiOS
Not supported Hypervisor
Four-port 10-GbE fiber SR NIC-1-010G-4SR-BP Not supported Slot 3 RiOS
Not supported Hypervisor
Four-port 10-GbE fiber LR NIC-1-010G-4LR-BP Not supported Slot 3 RiOS
Not supported Hypervisor
Four-port 10-GbE multimode
(Copper TX)
NIC-1-010G-4TX-BP Not supported Slot 3 RiOS
Not supported Hypervisor
Four-port 10-GbE multimode
(Copper ER)
NIC-1-010G-4ER-BP Not supported Slot 3 RiOS
Not supported Hypervisor
Four-port 10-GbE multimode
(Copper DAC)
NIC-1-010G-4DAC-BP Not supported Slot 3 RiOS
Not supported Hypervisor
SFP Manufacturing part number Orderable part number
SFP+ 10-GbE DAC 410-00142-01 TRC-1-SFPP-DAC
SFP+ 10-GbE SR 410-00143-01 TRC-1-SFPP-SR
SFP+ 10-GbE LR 410-00144-01 TRC-1-SFPP-LR
SFP 1-GbE LX 410-00140-01 TRC-1-SFP-LX
SFP 1-GbE SX 410-00139-01 TRC-1-SFP-SX
SFP 1-GbE copper 410-00138-01 TRC-1-SFP-TX
NIC description Orderable part number 1U slots
supported
2U slots
supported
Node