72 SteelFusion Edge Hardware and Maintenance Guide
Upgrading SteelFusion Edge Appliances Installing licenses and activating specifications
Upgrading a model
You perform the following steps to upgrade a model.
To perform a license-only upgrade
1. Install the model upgrade license.
You can install the model upgrade license in the CLI or the Management Console. For detailed
information, see “Installing licenses and activating specifications” on page 72. After you install the
license, the system indicates the model specifications available and if hardware is required for
activation.
2. Stop the service.
You need to stop the optimization service to activate a model upgrade specification.
3. Activate the specification.
Activate the model upgrade specification in the CLI or the Management Console. For detailed
information, see “Installing licenses and activating specifications” on page 72.
4. Restart the service.
Installing licenses and activating specifications
The following sections describe how to install model upgrade licenses and activate model
specifications using the CLI or the Management Console.
After you install a model upgrade license, you must stop the optimization service to activate the
model specification.
SFE 3200 W0 SFE 3200 W1 License only SF Edge 4.0 None None No
SFE 3200 W0 SFE 3200 W2 License only SF Edge 4.0 None None No
SFE 3200 W0 SFE 3200 W3 License only SF Edge 4.0 None None No
SFE 3200 W1 SFE 3200 W2 License only SF Edge 4.0 None None No
SFE 3200 W1 SFE 3200 W3 License only SF Edge 4.0 None None No
SFE 3200 W2 SFE 3200 W3 License only SF Edge 4.0 None None No
SFE 5100 W0 SFE 5100 W1 License only SF Edge 4.0 None None No
SFE 5100 W0 SFE 5100 W2 License only SF Edge 4.0 None None No
SFE 5100 W1 SFE 5100 W2 License only SF Edge 4.0 None None No
Source Model Destination
model
Upgrade
requirements
Minimum
software
version
Impact on
data store
Impact on
configuration
Reboot
required
To Next Page
Loading...