96 SteelFusion Edge Hardware and Maintenance Guide
Monitoring and Managing the Appliances with BMC Viewing field-replaceable unit information
Configuring the network
Initially, you configure the network settings for the BMC through the appliance CLI. You can use the
Configuration > Network page to manage or change the settings.
Note: RiOS will not recognize an IP address change made in the BMC. Use the appliance CLI to change the IP
address used to connect to the BMC module.
To change the network settings
1. Choose Configuration > Network.
2. Complete the configuration as described in this table.
3. Click Save.
You are prompted to log out of the current session and log back in at the new IP address.
4. Click Reset to revert the changes.
Control Description
LAN Interface Select the LAN interface to configure.
LAN Settings Check this option to enable LAN support for the selected interface.
MAC Address This read-only field displays the MAC address of the selected interface.
Obtain an IP
address
automatically
Enable Use DHCP to dynamically configure the IP address using Dynamic Host
Configuration Protocol (DHCP).
IPv4 Address,
Subnet Mask,
Default
Gateway
If DHCP is disabled, specify a static IP address, Subnet Mask, and Default
Gateway for the selected interface.
IPv6 Settings Check this option to enable IPv6 support for the selected interface.
Subnet Prefix
length
Specify the subnet prefix length for the IPv6 settings. Value ranges from 0 to
128.
VLAN Settings Check this option to enable VLAN support for the selected interface.
VLAN ID Specify the Identification for VLAN configuration. Value ranges from 2 to 4094.
VLAN ID 0, 1, and 4095 are reserved VLAN IDs. You cannot change the VLAN ID
without resetting the VLAN configuration.
VLAN Priority Specify the priority for VLAN configuration. Value ranges from 1 to 7. (7 is the
highest priority for the VLAN.)
To Next Page
Loading...
